Tria laser is a laser diode, which means an electric current is needed to accelerate the light inside the diode, and by using special ' mirrors ' light becomes very intense and laser beam has a high joule (light energy) level.
The process of laser hair removal works because light is turned on (thermal) heat energy when it is absorbed by the dark matter. Like a dark car in the Sun gets hotter than a white car under the Sun.
Because dark matter absorbs more light energy and turns off the heat when the hair pigment is darker than the surrounding skin, warm the BEAM up hair until the hair destructed inside the follicle-stimulating.
TRIA home laser device you see today is the upgraded version of the former system. The device has a nice sleek designed hand piece for comfortable use and easier hair removal sessions.
At the tip of the hand-piece is that laser projector, where the BEAM is expected from; on the top there is the digital displays to any treatment-related information, as well as energy levels are used, safety green light and battery life indication.
1. to perform a hair removal session, the TRIA device is fully charged. The charging time was reduced, and in the new model, it is 1.5 hours to fully recharge the system.
2. before laser treatment session to the skin be clean from any other chemical substance like-make up, lotions, shower oils, body creams and even perfume. This is because the light can be reflected by the heat that can cause adverse reactions to these chemicals.
3. For better performance it is recommended that the hair is shaved a day or two before, so the hair will not be above and below the skin surface. Floor wax machines is not recommended, because the wax pulls the hair from the root, and without a hair energy will burn the skin instead.
4. TRIA home laser device has a skin tone sensor to allow the person who uses it to ensure that the beam is safe for the skin being treated. Skin tone the sensor is near the bottom of the handset when you have verified that your skin tone is lower than ' type 4» skin tone, you're ready to go. The green light will be lit on the top view to let you know you're safe.
5. touch laser hint in the skin, and wait to hear the double beep when the two beeps were heard, the BEAM has been foreseen and the hand device can be moved to the next spot.
6. make sure that you overlap, since laser light peak is very precise and at each impulse only a few millimeters is been treated, sliding the tip a bit to the next spot. In the new model, you don't have to lift and press again (stamp of the proposal). Tria will function smoothly, as long as the three skin sensors are in contact with skin, safe operation reasons.
If you follow these six tips for safe laser removal session, you can enjoy a long-term hair reduction with less side effects and risks.
Need help evaluating the New TRIA Laser review? Visit http://dangersoflaserhairremoval.org/new-tria-laser-hair-removal-review/ for help with the new TRIA laser home system audit.
Act right now and link on the link above.
No comments:
Post a Comment